Dell FORCE10 Open Automation Manuel d'utilisateur télécharger pdf (Page 68)

68 | Virtual Server Networking CLI

www.dell.com | support.dell.com

type

Set the hypervisor type to which you want to connect.

Syntax

[no] type {vmware | xen-citrix}

Defaults

None

Parameters

Command Modes

HYPERVISOR

Usage

Information

You must configure a hypervisor type in order to enable VSN connections with

virtual servers. Use the

show hypervisor supported command to display the currently

supported hypervisor types.

Command

History

vsn enable

Enable VSN on an interface.

Syntax

[no] vsn enable

Defaults

VSN is disabled by default on switch interfaces.

Command Modes

INTERFACE

Command

History

Usage

Information

Enter the vsn enable command only on hypervisor-facing interfaces. DO NOT enter

this command on an interface used for inter-switch links.

Enter the

no vsn enable command to remove the VSN configuration from the system.

You must reconfigure VSN to re-enable a hypervisor session.

vmware Set the hypervisor type as VMware.

xen-citrix Set the hypervisor type as Xen-Citrix.

Version 8.3.8.0 Introduced on the S4810.

Version 8.3.5.1 Introduced on the S55.

Version 8.3.3.4 Introduced on the S60.

Version 8.3.8.0 Introduced on the S4810.

Version 8.3.5.1 Introduced on the S55.

Version 8.3.3.4 Introduced on the S60.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 97 98

Commentaires sur ces manuels

Pas de commentaire

Dell FORCE10 Open Automation Manuel d'utilisateur Page 68

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs Dell FORCE10 Open Automation