5. Pull the processor socket release lever straight up until the processor is released. See Figure6-9.
Figure 6-9. Removing the Processor
6. Remove the processor from the socket.
If you are replacing the processor, leave the release lever in the release position so that the socket is ready for the new processor and go to "Installing
a Processor."
7. If you are permanently removing the processor, rotate the release lever back toward the system board until it snaps into place.
While squeezing the tabs on retention module clip, lower the clip into the retention module base until it snaps into place. See Figure6-7. Repeat this
step for the second retention module clip.
8. Install the CPU_1 cooling shroud blank. See "Installing the Processor Cooling Shroud Blank."
9. Close the system. See "Closing the System" in "Troubleshooting Your System."
10. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Installing a Processor
Commentaires sur ces manuels