Dell PowerVault MD3000 Manuel d'utilisateur Page 23

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 120
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 22
Storage Array 23
System Setup for Password Reset
Microsoft
®
Windows
®
Operating Systems
1
Click
Start
Programs
Accessories
Communication
HyperTerminal
to run HyperTerminal.
If HyperTerminal is not installed, click
Control Panel
Add/Remove
Programs
Add/Remove
Windows Components
, find
HyperTerminal
and click the check-box, then click
Apply
and
OK
.
NOTE: The original Windows installation disk may be needed to install
HyperTerminal.
NOTE: HyperTerminal is not a component on Windows Server
®
2008 operating
systems.
2
When
HyperTerminal
prompts for a name, type
MD
and click
OK
.
3
Select the COM1 port and click
OK
.
4
Set the following communication settings, click
Apply
, then click
OK
.
Bits per second:
115200
Data bits:
8
Parity:
none
Stop bits:
1
Flow control:
none
LINUX Operating System
The following instructions use the Linux application, MINICOM, to connect
via the serial port:
1
Open a terminal/command window.
2
At the prompt, type
minicom
(all lowercase) and press <Enter>.
3
Once MINICOM is open, press <Ctrl><A>, then <Z>, then the letter
<O> to open the configuration screen.
4
Select
Serial Port Setup
and press <Enter>.
5
Press <F> to change
Hardware Flow Control
setting to
no
.
6
Press <E> to set the
Comm Parameters
.
Vue de la page 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 119 120

Commentaires sur ces manuels

Pas de commentaire