Dell PowerVault NX1950 Manuel d'utilisateur Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 258
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
Completing the Configuration 23
Completing the Configuration
After cabling the solution and setting up network addresses for the storage
system, you must perform the following steps to complete the configuration
of the PowerVault™ NX1950 storage solution. Before you configure the
system and storage arrays, ensure that:
The PowerVault NX1950 storage system and the storage arrays are cabled
correctly
You turn on the storage arrays and that the storage arrays complete
boot up before turning on the PowerVault NX1950 storage systems
After you turn on the PowerVault NX1950 storage system and log in
as an administrator, the following wizards launch in this order:
1
The
Dell Storage Initialization Wizard
launches and enables you
to configure the storage arrays.
2
The
PowerVault NX1950 Initial Configuration Tasks Wizard
launches
and enables you to configure the PowerVault NX1950 storage system.
Dell Storage Initialization Wizard
The PowerVault NX1950 storage solution is pre-configured with the
Dell Storage Initialization Wizard that automates the configuration of the
required components to connect your system to the attached storage array.
The Dell Storage Initialization Wizard runs every time you log on to the
PowerVault NX1950 storage system to verify that all system settings are
correct and no new storage arrays are attached.
After successfully configuring the storage arrays, the Dell Storage
Initialization Wizard exits and opens the PowerVault NX1950 Initial
Configuration Tasks Wizard automatically.
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 257 258

Commentaires sur ces manuels

Pas de commentaire