Dell OptiPlex GX100 Manuel d'utilisateur Page 25
- Page / 107
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Connecting Drives
When you install a drive, you connect two cables—a DC power cable and an interface cable—to the back of the drive. Your drive’s power input
connector(towhichyouconnecttheDCpowercable)resemblestheconnectorshowninFigure13.
Figure 13. Power Cable Connector
The drive’s interface connector is a card-edge connector or a header connector, as shown in Figure 14.
Figure 14. Drive Interface Connectors
When you attach the interface cable to a drive, be sure to match the colored strip on the cable to pin 1 of the drive’s interface connector. For the
location of pin 1 on the drive’s interface connector, see the documentation that came with the drive.
When you disconnect an interface cable from the system board, be sure to press in on the locking tabs on the cable connector before you
disconnect the cable. When you attach an interface cable to the system board, be sure that the locking tabs snap into place so that the cable is
firmly attached to the connector on the system board.
Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the
other connector (see Figure 14). Keyed connectors ensure that the pin-1 wire in the cable (indicated by the colored strip along one edge of the
cable) goes to the pin-1 end of the connector.
The pin-1 end of a connector on a board or a card is usually indicated by a silk-screened "1" printed directly on the board or card.
NOTICE: When you connect an interface cable, do not reverse the interface cable (do not place the colored strip away from pin 1 of
the connector). Reversing the cable prevents the drive from operating and could damage the controller, the drive, or both.
Back to Contents Page
NOTE: Tape drives sold by Dell come with their own operating software and documentation. After you install a tape drive,
refer to the documentation that came with the drive for instructions on installing and using the tape drive software.
1
Power input connector
2
Power cable
1
Card-edge connector on drive
2
Notch
3
Interface cables
4
Colored strip
5
Header connector on drive
- Backing Up Your Files 2
- Basic Checks 2
- Look and Listen 3
- System Setup 4
- Replacing the Battery 5
- International Dialing Codes 7
- Americas Contact Numbers 8
- Europe Contact Numbers 10
- Features 16
- Before You Start Testing 16
- Advanced Testing 17
- Connecting Drives 25
- Riser Boards 26
- Installing an Expansion Card 28
- Removing an Expansion Card 29
- Troubleshooting the Monitor 31
- Troubleshooting the Keyboard 31
- Troubleshooting the Mouse 32
- Troubleshooting I/O Ports 32
- Back to Contents Page 34
- Help Overview 34
- Contacting Dell 34
- Technical Assistance 43
- Help Tools 43
- Problems With Your Order 44
- Product Information 44
- Before You Call 45
- Internal Views 48
- System Board Components 50
- System Board Jumpers 50
- System Board Labels 51
- Troubleshooting the Battery 61
- Troubleshooting Drives 63
- Hardware Features 65
- Software Features 65
- Manageability Features 66
- ENERGY STAR®Compliance 69
- Installing DIMMs 70
- Removing DIMMs 71
- System Messages 72
- System Beep Codes 74
- Warning Messages 75
- Diagnostics Messages 76
- Diagnostic LEDs 76
- Upgrading the Microprocessor 77
- Getting Started 81
- Chassis Intrusion 84
- AC Power Recovery 89
- Asset Tag 89
- Auto Power On 89
- Boot Sequence 89
- CPU Speed 90
- Integrated Devices 90
- Keyboard NumLock 92
- PCI IRQ Assignment 92
- Remote Wake Up 93
- Report Keyboard Errors 93
- System Data 94
- System Date 94
- System Memory 94
- System Security 94
- System Time 95
- ZIP Floppy Support 95
- Error Messages 96
- Input Errors 96
- Memory-Resident Programs 97
- Program Conflicts 97
- Memory Address Conflicts 97
- Processor 99
- System Information 99
- Graphics and Video 99
- Expansion Bus 100
- Key Combinations 101
- Controls and Indicators 101
- Physical 101
- Environmental 102
- Overview 105
- Entering System Setup 105
- System Setup Screen 105
- System Setup Navigation Keys 106
Produits connexes et manuels pour Ordinateurs Dell OptiPlex GX100
(27 pages)
Ordinateurs Dell XPS 710 Manuel d'utilisateur
(105 pages)
(105 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.526 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels