80 Installing System Components
Figure 3-2. Removing and Installing the Front Bezel
Opening and Closing the System
WARNING: Whenever you need to lift the system, get others to assist you. To
avoid injury, do not attempt to lift the system by yourself.
Opening the System
1
Unless you are installing a hot-swap component such as a hard drive or
power supply, turn off the system and attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2
Remove the front bezel. See "Removing the Front Bezel."
3
Rotate the system feet inward. See Figure 3-3.
4
Lay the system on its side as shown in Figure 3-3.
1 front bezel 2 lever
3 bezel tab slots (2) 4 bezel tabs (2)
book.book Page 80 Tuesday, September 15, 2009 10:08 AM
Commentaires sur ces manuels