Dell S4810-ON Guide d'installation télécharger pdf (Page 24)

Installing an AC Power Supply

To install an AC power supply, follow these steps.

NOTE: The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may

damage the PSU or the S4810–ON chassis.

NOTE: Ensure that the PSU is correctly installed. When the PSU is correctly installed, the power

connector is on the left side of the PSU and the status LED is at the top of the PSU (refer to the

following illustration).

Figure 10. Installing an AC Power Supply

1. PSU1

2. Fan Module

3. Fan Module

4. Cable Connector

5. PSU2

6. Grab Handle

NOTE: If you use a single PSU, you must install a blank plate in the other PSU slot. Dell Networking

recommends using power supply 2 (PSU2) as the blank plate slot.

1. Take the PSU out of the shipping box.

2. Use the grab handle to slide the PSU into the power supply bay.

3. Tighten the securing screw on the side of the PSU. Ensure that the PSU is secure.

4. Attach the power cables.

NOTE: The system powers up as soon as the cables are connected between the power supply

and the power source.

Power Supplies

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Pas de commentaire

Dell S4810-ON Guide d'installation Page 24