Dell PowerEdge R520 Guide d'installation télécharger pdf (Page 8)

English

Installing the Rack Rails and Cable Management

Arm

If the server will be kept in a server rack, install the Rack Sliding Rails and

the Cable Management Arm provided in the server package. Follow the

procedures outlined in the Rack Installation Instructions and the CMA

Installation Instructions provided in the assembly kits.

NOTE: The supplied Rack Sliding Rails are compatible with square and

round hole racks.

Connecting Cables

Refer to the server diagrams in the Overview section for the location of

the different connectors.

1. Connect the keyboard and mouse to an available USB connector

on either the front or the back of the server.

2. Connect a monitor to the video connector on the server.

3. Connect the server to your network using an Ethernet network

cable.

4. Connect the power cable to the power supply at the back of the

server.

5. If you are also installing an Avigilon HD NVR Storage Expansion

with your server, connect the server to the storage expansion.

See Connecting Storage Expansions on page 9 for more

information.

6. Press the power button on the front of the server. Check that the

server LED indicators display the correct status. See LED

Indicators on page 13 for more information.

Installing the Bezel

The bezel can be installed on the front of the server to help protect the

power button and hard drives against unauthorized access.

1. Slide the right end of the bezel against the right hinge of the

server.

2. Push the left end of the bezel against the server until it clicks into

place.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Pas de commentaire

Dell PowerEdge R520 Guide d'installation Page 8