Dell Studio XPS 435MT Spécifications télécharger pdf (Page 14)

8. Align the four screw holes on the hard drive with the screw holes on the hard drive bay.



9. Replace the four screws that secure the hard drive to the chassis.



10. Connect the power and data cables to the hard drive.



11. Ensure that all the cables are properly connected and firmly seated.



12. Replace the computer cover (see Replacing the Computer Cover).



13. Connect your computer and devices to electrical outlets, and then turn them on.

Replacing an Optical Drive



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Replacing the Computer Cover).



3. Remove the front panel (see Replacing the Front Panel).



4. Disconnect the power cable and the data cable from the back of the optical drive.



5. Remove the two screws securing the optical drive to the chassis.



6. Push and slide the optical drive out through the front of the computer.



7. If you are not replacing the drive:

a. Replace the drive panel insert (see Replacing the Drive Panel Insert).

b. Go to step 12.



8. If you are replacing the optical drive or installing a new one, slide the drive into place.



9. Align the screw holes in the optical drive with the screw holes in the optical drive bay.



10. Replace the two screws that secure the optical drive to the chassis.



11. Connect the power and data cables to the optical drive.



12. Replace the front panel (see Replacing the Front Panel).

screws (2)

system board connector (any available connector SATA0,

SATA1, SATA2, and SATA3)

power

cable

data cable

optical

drive



NOTE: If you are uninstalling the only optical drive in your computer and will not replace it at this time, disconnect the data cable from the system

board and set it aside.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Dell Studio XPS 435MT Spécifications Page 14

Commentaires sur ces manuels