Dell PowerEdge RAID Controller H800 Manuel d'utilisateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 178
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
Safety Instructions 13
You can also take the following steps to prevent damage from electrostatic discharge:
When unpacking a static-sensitive component from its shipping carton, do not remove the
component from the antistatic packing material until you are ready to install the
component. Just before unwrapping the antistatic package, be sure to discharge static
electricity from your body.
When transporting a sensitive component, first place it in an antistatic container
or packaging.
Handle all electrostatic sensitive components in a static-safe area. If possible,
use antistatic floor pads and work bench pads.
Battery Disposal
Your system may use a nickel-metal hydride (NiMH), lithium coin-cell, and/or a
lithium-ion battery. The NiMH, lithium coin-cell, and lithium-ion batteries are
long-life batteries, and it is possible that you may never need to replace them.
However, should you need to replace them, see the instructions included in the
section "Configuring and Managing RAID" on page 81.
NOTE: Do not dispose of the battery along with household waste. Contact your local waste
disposal agency for the address of the nearest battery deposit site.
NOTE: Your system may also include circuit cards or other components that contain
batteries. The batteries too must be disposed of in a battery deposit site. For information about
such batteries, see the documentation for the specific card or component.
Taiwan Battery Recycling Mark
PERC7.2_UG.book Page 13 Thursday, March 3, 2011 2:14 PM
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 177 178

Commentaires sur ces manuels

Pas de commentaire