Dell PowerVault MD3000 Manuel d'utilisateur télécharger pdf (Page 20)

20 Hardware Installation

Using the MD Storage Manager, update the MD3000 RAID controller

firmware to the latest version available on

support.dell.com

(

Support

→

Download Firmware

→

Download RAID Controller

Module Firmware

) and the NVSRAM (

Support

→

Download

Firmware

→

Download RAID Controller Module NVSRAM

Stop I/O and turn off all systems:

Stop all I/O to the array and turn off affected host systems attached to

the MD3000.

Turn off the MD3000.

Turn off any MD1000 enclosures in the affected system.

Referencing the applicable configuration for your rack (Figure 2-1 through

Figure 2-12), cable the MD1000 enclosure(s) to the MD3000.

Turn on attached units:

Turn on the MD1000 expansion enclosure(s). Wait for the expansion

status LED to light blue.

Turn on the MD3000 and wait for the status LED to indicate that the

unit is ready:

• If the status LEDs light a solid amber, the MD3000 is still coming

online.

• If the status LEDs are blinking amber, there is an error that can be

viewed using the MD Storage Manager.

• If the status LEDs light a solid blue, the MD3000 is ready.

After the MD3000 is online and ready, turn on any attached host

systems.

After the MD1000 is configured as the expansion enclosure to the

MD3000, restore the data that was backed up in step 1.

After they are online, the MD1000 enclosures are available for use within the

MD3000 system.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Pas de commentaire

Dell PowerVault MD3000 Manuel d'utilisateur Page 20