Dell PowerVault NX3500 Manuel d'utilisateur télécharger pdf (Page 57)

Installing System Components 57

Hard Drives

Your system supports two 3.5-inch SATA hard drives in 3.5-inch hot-swap

hard-drive carriers. The hard drives are connected to a SAS backplane through

hard-drive carriers and are hot-swappable.

Removing a Hard-Drive Carrier

CAUTION: Ensure that your operating system supports hot-swap drive

installation. See the documentation supplied with the operating system.

1 If applicable, remove the front bezel. See

"Front Bezel" on page 51.

Using the RAID management software, prepare the hard drive for removal.

Wait until the hard-drive indicators on the

hard-drive

carrier signal that

the drive can be removed safely.

See your storage controller

documentation for information about hot-swap hard drive removal.

If the

hard drive

has been online, the green

activity/

fault indicator flashes

as the

hard drive

is powered down. When the

hard-drive

indicators are

off, the

hard drive

is ready for removal.

See Figure 1-4.

3 Press the release button and open the

hard-drive

carrier release handle to

release the

hard-drive carrier

. See Figure 2-5.

Slide the hard-drive carrier out of the hard-drive bay.

CAUTION: To maintain proper system cooling, all empty hard-drive bays must

have drive blanks installed.

book.book Page 57 Monday, January 24, 2011 12:24 PM

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 117 118

Pas de commentaire

Dell PowerVault NX3500 Manuel d'utilisateur Page 57