Dell OptiPlex NX1 Manuel d'utilisateur télécharger pdf (Page 133)

Removing and Replacing Parts on the Mini Tower Chassis 6-17

([SDQVLRQ&DUGV

The computer has a removable expansion-card cage. The expansion-card cage

contains the riser board and any installed expansion cards. Dell recommends

that you remove the expansion-card cage first before removing or installing

expansion cards.

If you are not removing any expansion cards, leave the external cables

attached to them.

([SDQVLRQ&DUG&DJH

To remove the expansion-card cage, follow these steps:

1. Rotate the lever toward the back of the computer until it stops in the

upright position.

2. Slide the expansion-card cage out of the computer.

To replace the expansion-card cage, align the tabs on the left and right sides of

the expansion-card cage with the slots on the back and bottom of the chassis.

With the securing lever in its extended position, slide the expansion-card cage

into place.

lever

expansion-card cage

chassis

bottom slot

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 169 170

Pas de commentaire

Dell OptiPlex NX1 Manuel d'utilisateur Page 133