Dell Precision T3610 (Late 2013) Manuel d'utilisateur

Dell Precision Workstation T3610Owner's ManualRegulatory Model: D01TRegulatory Type: D01T004

7. baffle cover 8. power supply unit (PSU)9. PCI card 10. intrusion switchRemoving the Power Supply Unit (PSU)1. Follow the procedures in Before Worki

Removing the Cover1. Follow the procedures in Before Working Inside Your Computer.2. Lay down the computer on its side with the latch facing up.3. Lif

4. Lift the cover upward to a 45–degree angle, and remove it from the computer.Installing the Cover1. Place the computer cover on the chassis.2. Press

4. Remove the baffle cover from the computer.5. Disconnect the power cables from the system board.6. Remove the screws securing the PSU card to the sl

7. Remove the PSU card from the computer.Installing the PSU Card1. Replace the PSU card in its slot.2. Tighten the screws to secure the PSU card in it

4. Rotate and pull the bezel panel away from the computer to release the hooks on the opposite edge of the bezel from the chassis.Installing the Front

4. Unthread the cables from the latches.5. Press on the clasp to release the latch holding the cables on the side of the optical-drive cage.16

6. Press down on the latch and lift up the cables.7. Lift up the release latch on top of the optical-drive cage.8. Holding the release latch, slide th

Installing the Optical Drive 1. Lift the release latch, and slide the optical-drive cage inside the compartment.2. Press on the clasp to release the l

5. Slide the hard drive out of the compartment.6. If a 2.5–inch hard drive is installed, remove the screws and lift up the drive to remove it from the

Notes, Cautions, and WarningsNOTE: A NOTE indicates important information that helps you make better use of your computer.CAUTION: A CAUTION indicates

3. Disconnect the speaker cable from the system board.4. Press down the clasp, lift and remove the speaker.Installing the Speaker1. Replace the speake

Removing the Thermal SensorNOTE: The thermal sensor is an optional component and your computer may not ship with it.1. Follow the procedures in Before

4. Remove the USB 3.0 module from the chassis.5. Disconnect the cables to release the I/O panel.6. Remove the screws which secure the I/O panel to the

Installing the Input/Output (I/O) Panel1. Replace the I/O panel in its slot.2. Tighten the screws securing the I/O panel to the chassis3. Attach the c

3. Install:a. optical driveb. cover4. Follow the procedures in After Working Inside Your Computer.Removing the Memory1. Follow the procedures in Befor

3. Press the release latch away from the battery to allow the battery to pop-up from the socket. Lift the coin-cell battery out of the computer.Instal

4. Remove the screw that secures metal plate to the system fan.5. Press the latches on either side of the metal plate to release it.26

6. Lift the metal plate out of the chassis.7. Remove the screws that secure the drive bay.8. Slide the latch out to release the air baffle.27

9. Remove the air baffle out of the computer.10. Disconnect the system-fan cables from the system board.11. Remove the screws that secure system-fan a

12. Lift the system-fan assembly from the chassis.13. Pry away the grommets to remove the system fans from the system-fan assembly.CAUTION: Using exce

Contents1 Working on Your Computer... 5Before Work

Installing the System Fan1. Place the fans in the fan assembly and attach the grommets.2. Place the fan assembly in the chassis.3. Install the screws

4. Install the cover.5. Follow the procedures in After Working Inside Your Computer.Removing the Heatsink Fan1. Follow the procedures in Before Workin

3. To remove the processor:NOTE: The processor cover is secured by two levers. They have icons that indicate which lever needs to be opened first and

6. Follow the procedures in After Working Inside Your Computer.Removing the System Board1. Follow the procedures in Before Working On Your Computer.2.

4. Remove the screws that secure the system board to the chassis.5. Lift the system board in an upward direction and remove it from the computer.Insta

4. Install:a. processorb. memory module(s)c. coin-cell batteryd. heatsink fane. heatsinkf. speakerg. I/O panelh. PCI cardi. PSU cardj. system fank. ha

1. PCI slot (slot 6) 2. PCIe x16 slot (PCIe 2.0 wired as x4) (slot 5)3. PCIe 3.0 x16 slot (slot 4) 4. PCIe 2.0 x1 slot (slot 3)5. PCIe 3.0 x16 slot (s

3Additional InformationThis section provides information for the additional features that are part of your computer.Memory Module GuidelinesTo ensure

38

4System SetupSystem Setup enables you to manage your computer hardware and specify BIOS‐level options. From the System Setup, you can:• Change the NVR

Removing the Processor...

Keys Navigation<Enter> Allows you to select a value in the selected field (if applicable) or follow the link in the field.Spacebar Expands or co

Option DescriptionDate/Time Allows you to set the date and time. The changes to the system date and time takes effect immediately.Table 3. System Conf

Option Description• SATA2–HDD2• SATA2–ODD0• SATA3–HDD1• SATA2–HDD3• SATA2–ODD1Default Setting: All drives are enabled.NOTE: If the hard drives are con

Option Description• Enabled (Default)• DisabledTable 4. VideoOption DescriptionPrimary Video Slot Allows you to configure primary boot video device. T

Option DescriptionCPU XD Support Allows you to enable the Execute Disable mode of the processor.Default Setting: Enable CPU XD SupportOROM Keyboard Ac

Option DescriptionNOTE: • The options displayed could be different depending on the installed processor(s).• The options depend on the number of cores

Option DescriptionDeep Sleep Control Allows you to define the controls when Deep Sleep is enabled.• Disabled (Default)• Enabled in S5 only• Enabled in

Option Description• Enable Intel Virtualization Technology - This option is enabled by default.VT for Direct I/O Enables or disables the Virtual Machi

11. Select your preferred download method in the Please select your download method below window; click Download File.The File Download window appears

8. Press <Y> to save the changes.The computer reboots.Deleting or Changing an Existing System and/or Setup PasswordEnsure that the Password Stat

1Working on Your ComputerBefore Working Inside Your ComputerUse the following safety guidelines to help protect your computer from potential damage an

50

5DiagnosticsIf you experience a problem with your computer, run the ePSA diagnostics before contacting Dell for technical assistance. The purpose of r

52

6Troubleshooting Your ComputerYou can troubleshoot your computer using indicators like Diagnostic Lights, Beep Codes, and Error Messages during the op

• If available, install verified working memory of the same type into your computer.A possible graphics card failure has occurred.• Ensure that the di

A possible system board failure has occurred.• Disconnect all internal and external peripherals, and re-start the computer. If the computer boots, add

Errors That Soft Halt Your ComputerThese error messages will cause a soft halt of your computer and you will be prompted to press <F1> to contin

7Technical SpecificationsNOTE: Offerings may vary by region. The following specifications are only those required by law to ship with your computer. F

Feature SpecificationT3610 / T5610 / T7610 4 GBMaximum memoryT3610 / T5610 128 GBT7610 512 GBTable 19. VideoFeature SpecificationDiscrete (PCIe 3.0/2.

Feature SpecificationUSB:Front ports USB 3.0, 5 Gbps (1 port); USB 2.0, 480 Mbps (3 ports)Rear ports USB 3.0, 5 Gbps (3 ports); USB 2.0, 480 Mbps (3 p

6. Remove the cover.CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal

Feature SpecificationT7610 two RJ-45Serial one 9-pin connectorUSBT3610 / T5610 / T7610• front panel — three USB 2.0, and one USB 3.0• back panel — thr

Feature SpecificationPCI 2.3 one 124-pin connectorFront I/O:Front USB one 14–pin connectorInternal USB one type A female, one dual-port 2x5 headerFron

Feature Specificationamber/blinking light — see the service manual for specific diagnostic codes.Table 27. PowerFeature SpecificationCoin-cell battery

Feature SpecificationHeight (with feet) 433.40 mm (17.06 inches)Height (without feet) 430.50 mm (16.95 inches)Width 216.00 mm (8.51 inches)Depth 525.0

64

8Contacting DellNOTE: If you do not have an active Internet connection, you can find contact information on your purchase invoice, packing slip, bill,

5. If required, verify that the computer works correctly by running the Dell Diagnostics.7

8

2Removing and Installing ComponentsThis section provides detailed information on how to remove or install the components from your computer.Recommende