Dell XPS/Dimension XPS Gen 2 Manuel d'utilisateur télécharger pdf (Page 12)

8. Close the computer cover.



9. Connect your computer and devices to electrical outlets, and then turn them on.

10. Click the Start button, right-click My Computer, and then click Properties.

11. Click the General tab.

12. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.



PCI Cards



YourDell™computerprovidesslotsforuptofour32-bit, 33-MHz cards. For more information, see "Specifications."



Installing a PCI Card

1. If you are replacing a card, remove the current driver for the card from the operating system.

2. Follow the instructions in "Before You Begin."

3. Open the computer cover.

4. Press the lever on the card retention arm and raise the retention arm.



5. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with step 7.

6. If you are replacing a card that is already installed in the computer, remove the card.



If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.

7. Prepare the card for installation.



See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your

computer.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.

NOTE: For optimum performance, install a PCI sound card only in PCI slot 3 or 4 and a modem card only in PCI slot 2, 3, or 4.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Dell XPS/Dimension XPS Gen 2 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Dell XPS/Dimension XPS Gen 2