Dell 1400 Manuel du propriétaire télécharger pdf (Page 13)

Installing the front bezel

1. Hook the right end of the bezel onto the chassis.

2. Fit the free end of the bezel onto the system.

3. Secure the bezel with the keylock.

Hard disk drives

Safety: Models AMT, E03J, and E04J

Models AMT, E03J, and E04J are intended for installation only in restricted access locations as defined in

cl 1.2.7.3 of IEC 60950-1:2005.

On the basis of your configuration, your enclosure either supports up to up to 12 3.5-inch SAS hard disk

drives in internal drive bays. Hard disk drives are connected to a backplane using hard disk drive carriers

and are configured as hot-swappable.

CAUTION: Do not turn off or reboot your enclosure while the hard disk drive is being formatted.

Doing so can cause a hard disk drive to fail.

When you format a hard disk drive, allow enough time for the formatting to complete. High-capacity

hard disk drives can take many hours to format.

Removing a hard disk drive blank

CAUTION: To maintain proper system cooling, make sure all empty hard disk drive bays have

blanks installed.

1. If installed, remove the front bezel. See Removing the front bezel.

2. Press the release tab and pull the hard disk drive blank out until it is free of the hard disk drive bay.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Pas de commentaire

Dell 1400 Manuel du propriétaire Page 13