Dell PowerEdge 4220 Guide d'installation télécharger pdf (Page 8)

A Principled Technologies setup guide 8

A quick and easy guide to setting up the Dell PowerEdge C8000

Connecting Ethernet cables to management ports

For Non-Central Consolidated Mode, run Ethernet

cables from your network switch to the management port on

the front right of the Dell PowerEdge C8000 enclosure as the

yellow cables in Figure 6 show. You can also run Ethernet cables

to the rear BMC management port (see Figure 7). Before setting

up the BMC, connect the sled to a local console and configure

the BMC NIC in the BIOS F2 setup menu. In this configuration,

you need not plug a network cable into the management port

on the front of the compute sled (see Figure 8).

In the alternative management configuration, Non-

Central Independent Mode, you would plug the Ethernet cable

into the front BMC port on each compute sled as highlighted in

Figure 8. You would not plug any Ethernet cables into the BMC

chassis ports using the Non-Central Independent Mode

installation.

Figure 6: Management port Ethernet cable installation.

Figure 7: Rear BMC management port on chassis.

Figure 8: Management port

on compute sled.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Dell PowerEdge 4220 Guide d'installation Page 8