Dell DR4000 Manuel d'utilisateur télécharger pdf (Page 45)

64 bytes from 10.25.19.5: icmp_seq=3 ttl=64 time=0.047 ms

--- 10.25.19.5 ping statistics ---

3 packets transmitted, 3 received, 0% packet loss, time 5999ms

rtt min/avg/max/mdev = 0.032/0.043/0.049/0.005 ms

--size

Specify a desired ping packet size by entering a value using the DR Series system CLI --size command option.

Example

network --ping --destination system-69 --size 35

PING 10.20.19.20 (10.20.19.20) from myDR4000 bond0: 35(63) bytes of data.

43 bytes from 10.20.19.20: icmp_seq=1 ttl=64 time=0.129 ms

43 bytes from 10.20.19.20): icmp_seq=2 ttl=64 time=0.163 ms

43 bytes from 10.20.19.20: icmp_seq=3 ttl=64 time=0.166 ms

43 bytes from 10.20.19.20: icmp_seq=4 ttl=64 time=0.237 ms

43 bytes from 10.20.19.20: icmp_seq=5 ttl=64 time=0.179 ms

--- 10.20.19.20.acme.local ping statistics ---

5 packets transmitted, 5 received, 0% packet loss, time 4000ms

rtt min/avg/max/mdev = 0.129/0.174/0.237/0.038 ms

--interface

Specify an interface address to use as the source address by entering a value using the DR Series system CLI --

interface command option.

Example

network --ping --destination system-69 --interface bond0

network --blink

Description

The command blinks the LED on the specific ethernet device.

Syntax

network --blink --nwif <ethN> --time <N>

--nwif Eth interface to blink.

--time Blink duration time in seconds (default 10, max 300).

For example, to blink the LED for eth3, run the command: network --blink --nwif eth3 --time 30

Result

Check the LED on the ethernet card on the back of the system for identification.

network --enable

Description

The command starts the specific ethernet device(s) on restart.

Syntax

network --enable [--bondif <bond0,bond1,...,bondN>]

[--nwif <eth0,eth1,...,ethN>]

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 149 150

Pas de commentaire

Dell DR4000 Manuel d'utilisateur Page 45