Dell T7810 Manuel du propriétaire télécharger pdf (Page 59)

at a time) until you have

identified all modules without

error. If available, install working

memory of the same type into

your computer.

3,4

Power connector not installed

properly.

Re-seat the 2x2 power

connector from the power

supply unit.

3,5

Memory modules are detected,

but a memory configuration or

compatibility error has occurred.

Ensure that no special

requirements for memory

module or connector placement

exist. Ensure that the memory

you are using is supported by

your computer.

3,6

A possible system board resource

and/or hardware failure has

occurred.

Clear CMOS (re-seat the coin-

cell battery. See removing and

Installing Coin-Cell battery).

3,7

Some other failure has occurred.

Ensure that the display or

monitor is plugged into a discrete

graphics card. Ensure that all

hard drives and optical-drive

cables are properly connected to

the system board. If there is an

error message on the screen

identifying a problem with a

device (such as the floppy drive

or hard drive), check the device

to make sure it is functioning

properly. If the operating system

is attempting to boot from a

device (such as the floppy drive

or optical drive), check system

setup to ensure the boot

sequence is correct for the

devices installed on your

computer.

Error Messages

There are three types of BIOS error messages that are displayed depending on the severity of the issue.

They are:

Errors That Halt Your Computer Completely

These error messages will halt the computer requiring you to cycle the system's power. The following

table lists the error messages.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Dell T7810 Manuel du propriétaire Page 59

Commentaires sur ces manuels

Produits connexes et manuels pour Mini PC Dell T7810