Dell 2407WFP Monitor Manuel d'utilisateur télécharger pdf (Page 34)



Using the OSD

Accessing the Menu System



1.Push the MENU button to launch the OSD menu and display the main menu.

Main Menu for Analog (VGA) Input

Main Menu for non Analog (non VGA) Input

2.Push the and buttons to move between the setting options. As you move from one icon to another, the option name is highlighted. See the

table for a complete list of all the options available for the monitor.

3.PushtheMENUbuttononcetoactivatethehighlightedoption.



PIP / PBP Select



Use this button to activate PIP (Picture-in-Picture) / PBP (Picture-by-Picture)modesadjustment.

Pressing this button continually cycles the monitor through the following modes : OFF-->PIP--

>PBP. You will see the following

messages corresponding to the mode selected.



→



→



OSD Menu / Select

The MENU button is used to launch the on-screen display(OSD) and select the OSD Menu. See Accessing the Menu System

Down (-) and Up (+)

Use these buttons for navigating and adjusting the slider-bar(decrease/increase ranges) controls in the OSD.

Power button

(withpowerlightindicator)

The green LED indicates the monitor is on and fully functional. An amber LED indicates DPMS power save mode.

The Power button turns the monitor on and off.

NOTE: Ifyouchangethesettingsandtheneitherproceedtoanothermenu,orexittheOSDmenu,themonitorautomaticallysavesthosechanges.The

changes are also saved if you change the settings and then wait for the OSD menu to disappear.



NOTE: AUTO ADJUST is only available when you are using the analog (VGA) connector.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 50 51

Pas de commentaire

Dell 2407WFP Monitor Manuel d'utilisateur Page 34