Dell 3348 - PowerConnect Switch - Stackable Informations techniques télécharger pdf (Page 12)

12 System Information Guide

www.dell.com | support.dell.com

To install the switch in a rack:

1 Use the supplied screws to attach a mounting bracket to each side of the switch.

2 Position the switch in the rack and align the holes in the mounting bracket with the

holes in the rack.

3 Insert and tighten two screws appropriate for your rack through each of the mounting

brackets.

Stacking 3324 and 3348 Switches

PowerConnect 3324/3348 supports stacking up to six PowerConnect 3324/3348 devices.

Each PowerConnect

3324/3348 stack contains a single Master unit, while the remaining

units are considered stacking Members. All management is done through the Master unit.

Both 24-port and 48-port devices can be included in the stack.

To enable stacking, units must be stacked with an optional stacking module connected to

port G2, which is a small form factor pluggable (SFP) transceiver slot. The stacking module

should be inserted before any of the systems in the stack are booted.

NOTE: Insert the stacking module into the SFP transceiver slot, not the RJ-45 connector.

front

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 46 47

Pas de commentaire

Dell 3348 - PowerConnect Switch - Stackable Informations techniques Page 12