Dell Label Maker DCSM Manuel d'utilisateur télécharger pdf (Page 51)

2. Reset the current CMOS settings:

a. Locate the 2-pin CMOS jumper (RTCRST) on the system board.

b. Remove the jumper plug from pin 1.

c. Place the jumper plug on pins 1 and 2 and wait approximately five seconds.

d. Replace the jumper plug on pin 1.



3. Close the computer cover.



4. Connect your computer and devices to electrical outlets, and turn them on.

Back to Contents Page



NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

1 2 ... 46 47 48 49 50 51 52 53 54 55

Pas de commentaire

Dell Label Maker DCSM Manuel d'utilisateur Page 51