Dell Lifecycle Controller 2 Version 1.3.0 Guide d'installation télécharger pdf (Page 12)

12 Configuring VLAN Settings in Lifecycle Controller for Dell PowerEdge Servers

1.2.2 Setting Static IP as the IP Address Source

1. From the NIC Card drop-down menu, select a NIC Card.

2. From the IP Address drop-down menu, select Static, and then type data in the IP Address

Properties boxes.

3. To type the priority level and VLAN ID within the specified value, under Lifecycle Controller

VLAN Settings, select Enable.

Figure 8 VLAN Settings Enabled

Note: Make sure that the network cable is connected to the NIC card that is selected for the VLAN

settings.

A message is displayed to indicate that the network settings are successfully updated. A sample

screen shot is given here.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 24 25

Pas de commentaire

Dell Lifecycle Controller 2 Version 1.3.0 Guide d'installation Page 12