Dell Networking S6000 Guide de démarrage rapide Page 19
- Page / 37
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Installation 15
5
If you have a redundant PSU (a second PSU), repeat steps 1 through 4 above
using the second PSU slot.
NOTE: The system powers up as soon as the cables are connected between the
power supply and the power source.
Rack Mount the Switch
You may either place the switch on the rack shelf or mount the switch directly
into a 19" wide, EIA-310-E-compliant rack (four-post, two-post, or threaded
methods). The Dell ReadyRails™ system is provided for 1U front-rack and two-
post installations. The ReadyRails system includes two separately packaged rail
assemblies and two rails that are shipped attached to the sides of the switch.
WARNING: This is a condensed reference. Read the safety instructions in your
Safety, Environmental, and Regulatory information booklet before you begin.
CAUTION: Do not use the mounted Ready-Rails as a shelf or a workplace.
NOTE: The illustrations in this document are not intended to represent a specific
switch.
Rack Mounting Safety Considerations
• Rack loading — Overloading or uneven loading of racks may result in shelf
or rack failure, causing damage to the equipment and possible personal
injury. Stabilize racks in a permanent location before loading begins. Mount
the components beginning at the bottom of the rack, then work to the top.
Do not exceed your rack load rating.
• Power considerations — Connect only to the power source specified on the
unit. When you install multiple electrical components in a rack, ensure that
the total component power ratings do not exceed the circuit capabilities.
Overloaded power sources and extension cords present fire and shock
hazards.
• Elevated ambient temperature — If installed in a closed rack assembly, the
operating temperature of the rack environment may be greater than the room
ambient temperature. Use care not to exceed the 40
°
C maximum ambient
temperature of the switch.
• Reduced air flow — Install the equipment in the rack so that the amount of
airflow required for safe operation of the equipment is not compromised.
- Getting Started Guide 1
- Notes, Cautions, and Warnings 2
- Contents 3
- About this Guide 5
- 2 About this Guide 6
- Introduction 7
- 4 Introduction 8
- I/O Panel 10
- Utility Panel 11
- System Status 13
- Hardware Overview 14
- Installation 17
- Rack Mount the Switch 19
- Installation 17 21
- Installation 19 23
- Installing the Switch 24
- Installation 21 25
- Refer to 25
- 22 Installation 26
- Technical Specifications 27
- Power Requirements 28
- Installing the Software 29
- Default Configuration 31
- Configuring a Host Name 31
- Accessing the System Remotely 32
- Creating a Port-based VLAN 34
- 1 Access INTERFACE 35
- 2 Enable an interface to 35
- 2 Configure an interface 35
- Printed in the U.S.A 37
Produits connexes et manuels pour Mise en réseau Dell Networking S6000
(30 pages)
(27 pages)Electrolux Air-O-Convect AOS102GCD1 manuals
Owner’s manuals and user’s guides for Convection ovens Electrolux Air-O-Convect AOS102GCD1.
We providing 1 pdf manuals Electrolux Air-O-Convect AOS102GCD1 for download free by document types: User Manual
Commentaires sur ces manuels