7. By default, the IP address and subnet mask of the out-of-band management interface used for
remote SNMP or Telnet access is assigned by a DHCP server. You can reconfigure the default setting
by specifying an IP address with the following commands:
interface ManagementEthernet slot/port, where slot is 0 and port is 0.
ip address ip-address/mask, where ip-address is in dotted-decimal format (A.B.C.D) and
mask is a subnet mask in /prefix-length format (/xx).
no shutdown enables the interface.
Dell(conf)# interface ManagementEthernet 0/0
Dell(conf-if-ma-0/0)# ip address 128.0.0.1/24
Dell(conf-if-ma-0/0)# no shutdown
8. To reconfigure the default route used by the out-of-band interface to access the aggregator from a
remote network, enter the management route subnet/mask managementethernet command,
where the subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a subnet mask that
defines the out-of-band management network:
Aggregator1(conf)#management route 10.0.0.0/16 128.0.0.5
9. By default, the IP address of the default VLAN used to access the switch from an in-band routing
interface is assigned by a DHCP server. You can reconfigure the default setting by specifying an IP
address with the ip address ip-address/mask command:
Dell(conf)# interface vlan 1
Dell(conf-if-vl-1)# ip address 10.1.1.4/24
10. To reconfigure the default route used by the in-band management interface (default VLAN) used to
access the aggregator from a remote network, enter the ip route subnet/mask vlan 1
command, where the subnet/mask is an IP address in dotted decimal format (A.B.C.D) and a
subnet mask that defines the in-band management network:
Dell(conf)# ip route 10.1.1.0/24 vlan 1
11. By default, broadcast storm control is enabled on the aggregator to limit unregistered unicast,
multicast, and broadcast packets. To disable storm control, enter the no io-aggregator
broadcast storm-control
command:
Dell(conf)# no io-aggregator broadcast storm-control
12. By default, IGMP multicast flooding is enabled on the aggregator. To disable multicast flooding to
send unregistered multicast packets only to interested hosts in a VLAN, enter the no ip igmp
snooping flood command:
Dell(conf)# no ip igmp snooping flood
13. To verify the reconfigured settings, enter the show running-config command:
Dell# show running-config
14. To save the reconfigured settings to the startup configuration, enter the write memory command:
Dell# write memory
For more information about aggregator configuration, refer to the Dell Networking Configuration Guide
for the Dell PowerEdge FN 410S I/O Aggregator.
Aggregator Auto-Configuration
After the aggregator powers on, it auto-configures and is operational with the following software features
enabled:
• VLANs: In Standalone mode, all ports are configured as members of all (4094) VLANs. All VLANs are
up and can send or receive Layer 2 traffic.
For more information, refer to Configuring VLANs.
• Data center bridging capability exchange protocol (DCBX).
• Fiber Channel over Ethernet (FCoE) connectivity.
Installing and Configuring the Aggregator
19
(24 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels