Dell B2360d Mono Laser Printer Manuel d'utilisateur Page 114
- Page / 153
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer,
press
and on the printer control panel simultaneously for 15 seconds to clear the message and continue
printing.
If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install
a genuine Dell supply or part.
Note: For the list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit
www.dell.com/printers.
Paper too short [34]
Try one or more of the following:
• Load the correct size of paper in the tray.
• From the printer control panel, press to clear the message and print using a different tray.
• Check the tray length and width guides and make sure the paper is loaded properly in the tray.
• Make sure the correct paper size and type are specified in Print Properties or in the Print dialog.
• Make sure the paper size and type settings are specified in the Paper menu on the printer control panel.
• Make sure the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, then make sure the
paper is large enough for the data being printed.
• Cancel the print job.
Parallel port disabled [56]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
Note: The printer discards any data received through the parallel port.
• From the printer control panel, set Parallel Buffer to Auto.
Printer restart. Check last job.
Press on the printer control panel to clear the message and continue printing.
For more information, visit
www.dell.com/support/printers or contact technical support.
Rear USB port disabled [56]
Try one or more of the following:
• From the printer control panel, press to clear the message and continue printing.
Note: The printer discards any data received through the USB port.
• From the printer control panel, set USB Buffer to Auto.
Troubleshooting 114
- User's Guide 1
- Contents 2
- Contents 3 3
- Contents 4 4
- Safety information 5
- Learning about the printer 7
- Printer configurations 9
- Learning about the printer 10 10
- Learning about the printer 11 11
- Using the Embedded Web Server 12
- Learning about the printer 13 13
- Additional printer setup 14
- Installing an optional card 15
- Additional printer setup 16 16
- Installing hardware options 17
- Attaching cables 18
- Installing the printer 19
- For Windows users 20
- For Macintosh users 20
- Verifying printer setup 24
- Printing a network setup page 25
- Loading trays 27
- 6 Insert the tray 31
- Linking and unlinking trays 35
- Assigning a custom paper type 36
- 4 Click Submit 37
- Paper guidelines 38
- Fiber content 39
- Unacceptable paper examples 40
- Using specialty media 41
- Tips on using labels 42
- Tips on using letterhead 42
- Tips on using transparencies 42
- Storing paper 43
- Printing 46
- Printing from a mobile device 47
- Menus list 49
- Paper menu 49
- Paper Size/Type menu 50
- Configure MP menu 53
- Substitute Size menu 53
- Paper Texture menu 53
- Paper Weight menu 55
- Paper Loading menu 56
- Custom Types menu 57
- Universal Setup menu 57
- Reports menu 58
- Network/Ports menu 59
- Network Card menu 60
- TCP/IP menu 61
- IPv6 menu 62
- Wireless menu 63
- AppleTalk menu 63
- Standard USB menu 64
- SMTP Setup menu 65
- Security menu 66
- Set Date and Time menu 67
- Settings menu 68
- Setup menu 72
- Finishing menu 73
- Quality menu 75
- Utilities menu 76
- XPS menu 76
- PostScript menu 76
- PCL Emul menu 77
- Use both sides of the paper 80
- Avoid paper jams 80
- Adjusting Sleep mode 81
- Using Hibernate mode 82
- Setting Hibernate Timeout 82
- Using Schedule Power Modes 82
- Recycling 83
- Securing the printer 84
- Erasing volatile memory 85
- Erasing non‑volatile memory 85
- Maintaining the printer 86
- Ordering supplies 87
- Storing supplies 87
- Replacing supplies 88
- Replacing the imaging unit 89
- 8 Close the front door 91
- Moving the printer 92
- Managing the printer 93
- Viewing reports 94
- Clearing jams 97
- Load paper properly 97
- Use recommended paper 98
- Jam, front door [20y.xx] 99
- Jam, rear door [20y.xx] 102
- Jam, standard bin [20y.xx] 103
- Pull out the tray completely 104
- Clearing jams 104 104
- 4 Insert the tray 105
- Jam, tray [x] [24y.xx] 106
- Jam, MP feeder [250.xx] 106
- Troubleshooting 108
- Insert tray [x] 111
- Memory full [38] 113
- Network error, port [x] [54] 113
- Paper too short [34] 114
- Parallel port disabled [56] 114
- Rear USB port disabled [56] 114
- The printer is not responding 116
- • The USB symbol on 117
- • The appropriate 117
- Printer display is blank 118
- Cannot detect internal option 118
- Tray problems 119
- Paper frequently jams 120
- Troubleshooting 121 121
- Print jobs do not print 122
- Printing slows down 123
- Troubleshooting 124 124
- Incorrect characters print 125
- Tray linking does not work 125
- Large jobs do not collate 125
- Unexpected page breaks occur 126
- Troubleshooting 127 127
- Clipped pages or images 128
- Troubleshooting 129 129
- Gray background on prints 130
- Incorrect margins on prints 131
- Paper curl 132
- Print irregularities 133
- Print is too dark 134
- Troubleshooting 135 135
- Print is too light 136
- Skewed print 137
- Troubleshooting 138 138
- Troubleshooting 139 139
- Troubleshooting 140 140
- Troubleshooting 141 141
- Troubleshooting 142 142
- Toner specks appear on prints 143
- Toner rubs off 143
- Uneven print density 143
- Troubleshooting 144 144
- Contacting technical support 145
- Appendix 146
- Warranty and Return Policy 147
Produits connexes et manuels pour Imprimeurs Dell B2360d Mono Laser Printer
(102 pages)
(12 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.799 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels