Dell 4.x Guide de l'utilisateur télécharger pdf (Page 38)

38 ESXi Deployment Guide

Optionally, restore the host to the ESXi build number used when the

backup file was created.

The backup process does not support restoring to later builds; though, this

requirement can be overridden by using the

–f

option.

Start the vSphere CLI on a host other than the host you want to restore

and log in.

Run the

vicfg-cfgbackup

command with the

–l

flag to load and

restore the backup file to the host.

vicfg-cfgbackup --server <ESXi-host-IP> --

portnumber <port_number> --protocol

<protocol_type>-- username <username> --password

The

-portnumber

and

-protocol

options are optional. If you

exclude them, the defaults are port

443

and protocol

HTTPS

NOTE: If you do not specify a password in the command line, you are

prompted for one when the command executes. For example:

vicfg-

cfgbackup --server 172.17.13.211 --username

root –l backupdate.dat

After a successful restore, the system reboots using the new configuration.

For complete instructions on backup and restore commands, see the

VMware

ESXi Embedded and vCenter Server Setup Guide

vmware.com/support/pubs

Troubleshooting

This section provides troubleshooting steps for common issues encountered

during deployment of ESXi.

ESXi Not Booting or Displays a “No OS found” Message at Start Up

Check the boot order. The correct storage device may no longer be selected

as the first boot device. This can happen if the device has recently been

removed due to failure. To correct this issue, ensure that the internal

storage drive on which ESXi is installed is assigned as the first boot device

in the hard drive sequence and the hard drive is assigned as the first boot

device in the boot sequence.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Dell 4.x Guide de l'utilisateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs Dell 4.x