Dell Force10 S55T Manuel de démarrage rapide télécharger pdf (Page 24)

22 Installing the Software

Configure a Username and Password

Configure a system username and password to access the system remotely.

Configure the Enable Password

The EXEC Privilege mode is unrestricted by default. Configure a password as a

basic security measure. There are two types of enable passwords:

• enable password stores the password in the running/startup configuration

using a DES encryption method.

• enable secret is stored in the running/startup configuration in using a

stronger, MD5 encryption method.

Dell Force10 recommends using the enable secret password.

Task Command Syntax Command Mode

Configure a

management route to

the network from

which you are

accessing the system.

management route ip-address/mask

gateway

CONFIGURATION

Task Command Syntax Command Mode

Configure a username

and password to

access the system

remotely.

username username password

[encryption-type]

CONFIGURATION

Task Command Syntax Command Mode

Create a password to

access EXEC

Privilege mode.

enable [password | secret] [level level]

[encryption-type] password

CONFIGURATION

1 2 ... 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Dell Force10 S55T Manuel de démarrage rapide Page 24