Dell Lifecycle Controller 1.3 Livre blanc télécharger pdf (Page 9)

Enhancements to iDRAC7 Alert Notification

You can then configure up to eight destination addresses for delivery of any SNMP alert. You can

configure the destination address using IPv4 address, IPv6 address, or a FQDN. See Figure 6.

To receive the SNMP alert, the community string for iDRAC needs to be the same as the destination

community string. By default, the value of the iDRAC community string is set to public. See Figure 6.

Setting a destination address Figure 6.

Configuring SNMP trap alerts using RACADM commands

To configure the trap destination address for IPv4:

racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIPAddr -i [index]

[IP-address]

where [index] is the trap destination index and [IP-address] is the destination IP address of the

system that receives the platform event alerts

To configure the trap destination address for IPv6:

racadm config -g cfgIpmiPetIpv6 -o cfgIpmiPetIpv6AlertDestIPAddr -i

[index] [IP-address]

where [index] is the trap destination index and [IP-address] is the destination IP address of the

system that receives the platform event alerts

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Dell Lifecycle Controller 1.3 Livre blanc Page 9