Dell Lifecycle Controller 1.4 Manuel d'utilisateur télécharger pdf (Page 23)

Remote Services Operations 21

Select

Enable

to enable the Auto-Discovery feature.

NOTE: Auto-Discovery feature will not run if the administrator

accounts are enabled.

Save and exit iDRAC6 Configuration Utility.

Restart your system.

Auto-Discovery Workflow

This is the Auto-Discovery workflow once it is configured and enabled:

Plug in your new Dell system to your network.

Plug-in the power cables to turn on the system.

iDRAC starts, acquires the Provisioning Server IP addresses/hostnames

from DHCP/DNS and announces itself to the Provisioning Server.

The Provisioning Server validates and accepts the secure handshake

session from the iDRAC.

The Provisioning Server provides custom user credentials with

administrator privileges to iDRAC.

iDRAC receives and completes the secure handshake.

With enhancements to the Auto-Discovery process you can:

• Configure the provisioning server host address through the iDRAC

Configuration utility, Unified Server Configurator (USC), or using

WinRM commands instead of using DHCP or DNS.

• Remotely reinitiate Auto-Discovery in new environments.

• Upload custom client and server certificates using WS-Management.

RemoteServices1_4.book Page 21 Thursday, October 21, 2010 5:05 PM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 91 92

Pas de commentaire

Dell Lifecycle Controller 1.4 Manuel d'utilisateur Page 23