Dell W-IAP93 Guide de l'utilisateur télécharger pdf (Page 56)

56 | Managing IAPs Dell PowerConnect W-Instant Access Point 5.0.3.0-1.1.0.0 | User Guide

3. Click OK.

Removing an W-IAP from the Network

An W-IAP can be manually removed from the network only if the Auto Join Mode feature is disabled. To

manually remove an W-IAP from the network, perform the following steps:

1. In the Access Points tab, click the W-IAP which you want to delete. An x appears against the W-IAP.

2. Click x to confirm the deletion.

Editing W-IAP Settings

This section explains the steps required to edit the following W-IAP settings:

 Name

 IP Address

 Adaptive Radio Management (ARM) Configuration

 External Antenna Configuration

 Migrating from a Virtual Controller Managed Network to Mobility Controller Managed Network

Changing W-IAP Name

To change the W-IAP name, perform the following steps:

1. In the Access Points tab, click the AP of the W-IAP that you want to rename. The edit link appears.

Figure 44 Editing W-IAP Settings

2. Click the edit link.

NOTE: The deleted W-IAP(s) cannot join the Instant network anymore.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 139 140

Pas de commentaire

Dell W-IAP93 Guide de l'utilisateur Page 56