Dell PowerEdge 2600 Manuel d'utilisateur télécharger pdf (Page 5)

Information Update 1-3

This document provides updated information on the following topics for your system:

• Power rating

• NIC issues

• SCSI issues and features

• RAID controllers

•Novell

NetWare

6.0

•Red Hat

Linux

• Compatibility considerations

Power Rating

100–240 VAC, 50–60 Hz, 11.4 A

200–240 VAC, 50–60 Hz, 5.0 A

NIC Issues

Intel

PRO/100 and PRO/1000 NIC Identification

The Intel PROSet utility includes a feature that causes Intel embedded NIC LEDs to blink for

identification purposes. The identification feature works for any Intel add-in NICs installed in this

system. However, because the system does not contain the hardware required to support the

identification feature for embedded NICs, the feature is unavailable for the system’s Intel PRO/100

and PRO/1000 embedded NICs.

SCSI Issues and Features

Mixed-Mode SCSI Configuration Limitation

Mixed-mode configurations (channel A set to ROMB and channel B set to SCSI) use the RAID

firmware rather than the SCSI firmware. In RAID mode, you cannot change the settings for SCSI

tape drives; these settings are automatically negotiated with the SCSI devices.

SCSI Setup Features

The SCSI option ROM allows you to set up to four channels to be included in the boot order.

Select the four channels from within the SCSI Configuration Utility, which you can enter by

pressing <Ctrl><A> when prompted during the POST of the LSI SCSI controllers.

You can include channels from the embedded LSI Ultra 320 SCSI controller. Ensure that the hard

drive containing the operating system is set as one of these first four channels in the boot sequence.

The first device from each of the four channels is included as a boot option in the System Setup

program. See your system’s

User’s Guide

for information about using the System Setup program.

1 2 3 4 5 6 7 8 9 10 ... 51 52

Pas de commentaire

Dell PowerEdge 2600 Manuel d'utilisateur Page 5