Dell PowerVault MD3800i Manuel d'utilisateur télécharger pdf (Page 37)

3. On the General tab (for a local area connection) or the Networking tab (for all other connections),

select Internet Protocol (TCP/IP), and then click Properties.

4. Select Obtain DNS server address automatically or enter the preferred and alternate DNS server IP

addresses and click OK.

Setting Up Microsoft Host Network Using A WINS Server

NOTE: If you are using a DHCP server to allocate WINS server IP addresses, you do not need to add

WINS server addresses.

1. In the Control Panel, select Network connections.

2. Right-click the network connection you want to configure and select Properties.

3. On the General tab (for a local area connection) or the Networking tab (for all other connections),

select Internet Protocol (TCP/IP), and then click Properties.

4. Select Advanced → WINS tab and click Add.

5. In the TCP/IP WINS server window, type the IP address of the WINS server and click Add.

6. To enable use of the Lmhosts file to resolve remote NetBIOS names, select Enable LMHOSTS

lookup

7. To specify the location of the file that you want to import into the Lmhosts file, select Import

LMHOSTS and then select the file in the Open dialog box.

8. Enable or disable NetBIOS over TCP/IP.

Linux Host Setup

To set up a Linux host network, you must configure the IP address and netmask of each iSCSI port

connected to the storage array. The specific steps depend on whether you are configuring TCP/IP using

DHCP or configuring TCP/IP using a static IP address.

NOTE: The server IP addresses must be configured for network communication to the same IP

subnet as the storage array management and iSCSI ports.

Setting Up Linux Host Network Using DHCP

If you are using DHCP (root users only):

1. Edit the /etc/sysconfig/network file using

NETWORKING=yes HOSTNAME=mymachine.mycompany.com

2. Edit the configuration file for the connection you want to configure, either /etc/sysconfig/network-

scripts/ifcfg-ethX for (for Red Hat Enterprise Linux) or /etc/sysconfig/network/ifcfg-eth-id-

XX:XX:XX:XX:XX (for SUSE Enterprise Linux).

BOOTPROTO=dhcp

Also, verify that an IP address and netmask are not defined.

3. Restart network services using /etc/init.d/network restart.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 58 59

Pas de commentaire

Dell PowerVault MD3800i Manuel d'utilisateur Page 37