Dell Inspiron One 2305 (Mid 2010) Manuel d'utilisateur télécharger pdf (Page 81)



6. Wait for approximately five seconds to clear the password setting.



7. Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3.



8. Replace the system-board shield (see Replacing the System-Board Shield).



9. Replace the back cover (see Replacing the Back Cover).



10. Connect your computer and devices to electrical outlets, and turn them on.

Clearing CMOS Passwords



1. Follow the instructions in Before You Begin.



2. Remove the back cover (see Removing the Back Cover).



3. Remove the system-board shield (see Removing the System-Board Shield).



4. Locate the 3-pin CMOS reset jumper (CLR_CMOS) on the system board. (see System Board Components).



5. Remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1 and 2.

Inspiron One 2305

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.

WARNING: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

WARNING: The computer must be disconnected from the electrical outlet to clear the CMOS setting.

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 89 90

Pas de commentaire

Dell Inspiron One 2305 (Mid 2010) Manuel d'utilisateur Page 81