Dell OptiPlex 160 (Late 2008) Manuel d'utilisateur télécharger pdf (Page 13)

Removing the Hard Drive



1. Perform the procedure in Before Working on Your Computer.



2. Remove the hard drive bracket assembly (see Removing the Hard Drive Bracket Assembly).



3. Disconnect the SATA data/power cable from the hard drive.



4. Remove the four screws that secure the hard drive to the hard drive bracket assembly.



5. Lift the hard drive out of the assembly.

Replacing the Hard Drive



1. Replace all rubber grommets on the hard drive bracket that are damaged or missing.



2. Place the hard drive in the carrier with the label facing up and the cable connectors toward the open end of the bracket.



3. Secure the hard drive to the bracket assembly, affixing the four screws through the rubber grommets.



4. Connect the SATA data/power cable to the hard drive.

SATA hard drive power cable

fan cable

cable retaining clip

SATA data cable

bracket screw

captive screws (2)

screws (4)

hard drive connector

rubber grommets (4)

hard drive bracket assembly

NOTE: Replacement hard drive kits may be shipped with rubber grommets. These grommets must be replaced if any are damaged or missing from the

hard drive bracket assembly.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 62 63

Pas de commentaire

Dell OptiPlex 160 (Late 2008) Manuel d'utilisateur Page 13