Dell OptiPlex GX1 Guide d'installation télécharger pdf (Page 54)

Working Inside Your Computer: Dell OptiPlex GX1 Low-Profile Managed PC Systems

file:///C|/infodev/2013/eDoc/OpGX1/SQRG/computer.htm[2/21/2013 11:53:01 AM]

Replacing the Computer Cover

Use the following procedure to replace the computer cover:

1. Check all cable connections, especially those that might have come loose during your work. Fold

cables out of the way so that they do not catch on the computer cover. Make sure cables are not

routed over the drive cage—they will prevent the cover from closing properly.

2. Check to see that no tools or extra parts (including screws) are left inside the computer's chassis.

3. Replace the cover.

Face the front of the computer and hold the cover at a slight angle as shown in Figure 3

. While aligning

the back of the cover with the chassis, insert the cover hooks into the rectangular slots on the chassis.

(It may be helpful to look down into the chassis to verify that the hooks are in place.)

Pivot the cover down toward the back and into position. With both hands, press against the top edge of

the cover to make sure that the securing buttons click into place.

Figure 3. Replacing the Computer Cover

4. If you are using the optional floor stand, reattach it.

See "Using the Optional Stand for Vertical Orientation

" for instructions.

5. If you are using a padlock to secure your system, reinstall the padlock.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 102 103

Pas de commentaire

Dell OptiPlex GX1 Guide d'installation Page 54