Dell OptiPlex GX1 Guide d'installation télécharger pdf (Page 70)

Installing System Board Options: Dell OptiPlex GX1 Low-Profile Managed PC Systems

file:///C|/infodev/2013/eDoc/OpGX1/SQRG/options.htm[2/21/2013 11:53:02 AM]

Upgrading the Microprocessor

To take advantage of future options in speed and functionality, you can replace the microprocessor on your

system board with any Dell-supported microprocessor upgrade. Call your Dell sales representative for

information on available microprocessor upgrades.

The microprocessor upgrade kit includes a new single-edge contact (SEC) cartridge with heat sink assembly.

CAUTION: Before you remove the computer cover, see "Safety First — For You and Your

Computer."

The following procedure describes how to replace the microprocessor.

NOTE: Dell recommends that only a technically knowledgeable person perform this procedure.

1. Remove the computer cover according to the instructions in "Removing the Computer Cover

CAUTION: The SEC cartridge and heat sink can get extremely hot during system

operation. Be sure the assembly has had sufficient time to cool before you touch it.

2. Locate the SEC cartridge connector (labeled "SLOT1") and the microprocessor fan connector (labeled

"FAN") on the system board.

See Figure 1.

3. Disconnect the microprocessor fan cable from the connector on the system board.

4. Remove the SEC cartridge/heat sink assembly from the system board connector (see Figure 10).

Press outward and hold the guide-bracket assembly latches, grasp the SEC cartridge/heat sink

assembly firmly, and pull away from the connector on the system board. Lift the SEC cartridge/heat

sink assembly from the guide bracket assembly.

NOTE: You must use up to 15 pounds of force to disengage the SEC cartridge from the

connector.

Figure 10. Removing the Microprocessor

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 102 103

Pas de commentaire

Dell OptiPlex GX1 Guide d'installation Page 70