Dell PowerEdge C6145 Manuel du propriétaire télécharger pdf (Page 204)

204 | Installing System Components

4 Replace the hard-drive cage into the chassis. See Figure 3-43.

5 Replace the screws that secure the front-panel assembly to the chassis.

See Figure 3-43.

6 Replace the screws that secure the hard-drive cage to the chassis. See

Figure 3-42.

7 Connect front panel cables to the fan controller board. See Figure 3-48.

You must route these cables properly through the tabs on the chassis to

prevent them from being pinched or crimped.

8 Connect all the cables to the backplane. See Figure 5-3 for 3.5

" hard

drives and Figure 5-7 for 2.5

" hard drives.

You must route these cables properly through the tabs on the chassis to

prevent them from being pinched or crimped.

9 Close the system. See "Closing the System" on page 174.

10 Replace the hard drives. See "Installing a Hard Drive Into a Hard-Drive

Carrier" on page 109.

11 Reconnect the system to its electrical outlet and turn on the system,

including any attached peripherals.

Sensor Boards

Removing the Sensor Board for 3.5” Hard Drive System

CAUTION: Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your

product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came with

the product.

1 Recommend to turn off the system, including any attached peripherals,

and disconnect the system from the electrical outlet.

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 249 250

Pas de commentaire

Dell PowerEdge C6145 Manuel du propriétaire Page 204