Dell Dimension 3100/E310 Manuel d'utilisateur télécharger pdf (Page 38)



5. Slide the power supply approximately 1 inch towards the front of the computer.



6. Lift the power supply up and out of the computer.



Replacing the Power Supply



1. Slide the power supply into place.



2. Replace the screws that secure the power supply to the back of the computer frame.



3. Reconnect the DC power cables.



4. Connect the AC power cable to the connector.



5. Run the cables underneath the clips, and press the clips to close them over the cables.



6. Replace the computer cover.



7. Connect your computer and devices to electrical outlets, and turn them on.

Battery



Replacing the Battery

release button

power supply

screws (4)

AC power connector

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Pas de commentaire

Dell Dimension 3100/E310 Manuel d'utilisateur Page 38