Dell Dimension 3100/E310 Manuel d'utilisateur télécharger pdf (Page 47)



9. Locate the 3-pin password jumper (PSWD) on the system board and attach the jumper to pins 1 and 2 to reenable the password feature.



10. Replace the computer cover.



11. Connect your computer and devices to electrical outlets, and turn them on.

Clearing CMOS Settings



1. Follow the procedures in "Before You Begin."



2. Reset the current CMOS settings:

a. Locate the 3-pin CMOS jumper (RTCRST) on the system board.

b. Remove the jumper plug from pins 2 and 3.

c. Place the jumper plug on pins 1 and 2 and wait approximately five seconds.

d. Replace the jumper plug on pins 2 and 3.



3. Replace the computer cover.



4. Connect your computer and devices to electrical outlets, and turn them on.



Back to Contents Page

NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

Pas de commentaire

Dell Dimension 3100/E310 Manuel d'utilisateur Page 47