Dell Dimension 9200 Manuel d'utilisateur télécharger pdf (Page 18)



10. Click the General tab.



11. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.



Removing Memory



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. Press outward the securing clip at each end of the memory module connector.



4. Grasp the module and pull up.

If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.

Cards



YourDell™computerprovidesthefollowingslotsforPCIandPCIExpresscards:

l Three PCI card slots

l One PCI Express x1 card slot

l One PCI Express x16 card slot

l One PCI Express x4 card slot



PCI Cards

l If you are installing or replacing a card, follow the procedures in the next section.

l If you are removing but not replacing a card, see Removing a PCI Card.

l If you are replacing a card, remove the current driver for the card from the operating system.

l If you are installing or replacing a PCI Express card, see Installing a PCI Express Card.



Installing a PCI Card



1. Follow the procedures in Before You Begin.



2. Remove the computer cover (see Removing the Computer Cover).



3. If your computer includes a card retention mechanism to secure the x16 card, press the release tab downward gently and then pivot the mechanism

upward to access the card slots.

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your

computer's electronic components. You can do so by touching an unpainted metal surface on the computer.

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your

computer's electronic components. You can do so by touching an unpainted metal surface on the computer.

NOTE: Dell offers an optional customer kit for Audigy II and IEEE 1394 PCI add-in-cards that includes a front-mounted IEEE 1394 connector.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 62 63

Commentaires sur ces manuels

Pas de commentaire

Dell Dimension 9200 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Ordinateurs Dell Dimension 9200