Dell Dimension 9200 Manuel d'utilisateur télécharger pdf (Page 57)



2. Locate the 2-pin password jumper (CLRPSWD) on the system board (see System Board Components), and remove the jumper to clear the password.



3. Replace the computer cover (see Replacing the Computer Cover).



4. Connect your computer and monitor to electrical outlets, and then turn them on.



5. After the Microsoft®Windows®desktop appears on your computer, shut down the computer (see Turning Off Your Computer).



6. Turn off the monitor and disconnect it from the electrical outlet.



7. Disconnect the computer power cable from the electrical outlet, then press the power button to ground the system board.



8. Remove the computer cover (see Removing the Computer Cover).



9. Locate the 2-pin password jumper (CLRPSWD) on the system board (see System Board Components) and attach the jumper to pins 1 and 2 to re-

enable the password feature.



10. Replace the computer cover (see Replacing the Computer Cover).



11. Connect your computer and devices to electrical outlets, and then turn them on.

Clearing CMOS Settings



1. Follow the procedures in Before Working Inside Your Computer.



2. Reset the current CMOS settings:

a. Locate the 2-pin CMOS jumper (CLRCMOS) on the system board (see System Board Components).

b. Remove the jumper plug from the password jumper (CLRPSWD) pins 1 and 2.

c. Place the jumper plug on the CMOS jumper (CLRCMOS) pins 1 and 2 and wait approximately five seconds.

d. Remove the jumper plug and replace it on the password jumper (CLRPSWD) pins 1 and 2.



3. Replace the computer cover (see Replacing the Computer Cover).



4. Connect your computer and devices to electrical outlets, and then turn them on.

NOTE: When you receive your computer, the jumper plug is attached to pins 1 and 2.

NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer.

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTE: When you receive your computer, there is no jumper plug on the CMOS jumper.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 63

Pas de commentaire

Dell Dimension 9200 Manuel d'utilisateur Page 57