Dell Dimension L___cx Manuel d'utilisateur télécharger pdf (Page 121)

support.dell.com System Setup Program B-7

Peripheral Configuration Submenu

Figure B-4. Peripheral Configuration Submenu

Table B-5. Peripheral Configuration Submenu Options

Option Function

Serial port A Configures the serial port. Set this option to Auto (default),

Enabled, or Disabled. If set to Enabled, you can set the fol-

lowing additional options:

Base I/O O

Address

Available base I/O addresses are 3F8, 3E8, 2F8, and 2E8.

Interrupt Available interrupts are IRQ3RQ3 and IRQ4.

Parallel port Configures the parallel port. Set this option to Auto (default),

Enabled, or Disabled. Depending on the port setting, you

can set the following additional options:

Mode If Parallel Port is set to Auto or Enabled, available modes

are Output Only, Bi-Directional (default), ECP, and EPP.

NOTE: Refer to the device manufacturer's documentation

for information on which mode to use before changing this before changing this

setting.

Base I/O

Address

If port is set to Enabled, available base I/O addresses are

378 (default), 278, and 228.

Interrupt If port is set to Enabled, available interrupts are 7 and 5.

NOTE: The Glossary in the system Help defines abbreviations and acronyms.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 161 162

Pas de commentaire

Dell Dimension L___cx Manuel d'utilisateur Page 121