Dell Dimension L___cx Manuel d'utilisateur télécharger pdf (Page 45)

support.dell.com Installing Drives 3-3

Removing and Replacing a 3.5-Inch

Front-Panel Insert

Empty drive bays in the drive cage are covered by a front-panel insert. The insert for a

3.5-inch drive bay is mounted to the inside of the bezel.

After you have removed the bezel, remove the front-panel insert for the bay you plan

to use. From the back of the bezel, as shown From the back of the bezel, as shown in Figure 3-2, press the release tab to

the side. Then rotate the insert toward you, and remove it from the bezel.

Figure 3-2. Removing a 3.5-Inch Insert

If you permanently remove a drive from the drive cage, replace the front-panel insert

by inserting its two tabs into the slot in the bezel and rotating the insert forward until

it snaps into place.

insert

release tab

tabs (2)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 161 162

Pas de commentaire

Dell Dimension L___cx Manuel d'utilisateur Page 45