Dell OptiPlex E1 Manuel d'utilisateur télécharger pdf (Page 41)

Drive Hardware Removal (Low-ProfileChassis):Dell™OptiPlex™E1Systems

Drive Hardware | 3.5-Inch Diskette-Drive Removal | 5.25-Inch Drive Assembly Removal | Hard-Disk Drive Assembly Removal

Drive Hardware

3.5-Inch Diskette-Drive Removal



To remove the 3.5-inch diskette drive assembly, follow these steps:

1. Disconnect the DC power cable and the interface cable from the back of the diskette drive.

2. Press the (2) 3.5-inch diskette-drive assembly latches to the left to release the assembly.

3. Rotate the left side of the assembly up, and lift the assembly out of the chassis.

4. Remove the 2 drive mounting screws from the left side of the drive, and remove the drive from the bracket.

When you replace the 3.5-inch diskette drive, be sure that the mounting holes on the right side of the drive engage the 2 hooks on the bracket.

5.25-Inch Drive Assembly Removal

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 74 75

Pas de commentaire

Dell OptiPlex E1 Manuel d'utilisateur Page 41