Dell 10g Guide de l'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 78
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
24 Deployment Guide
4
On all nodes, add the public, private, and virtual IP addresses and host name to
the
%SystemRoot%\system32\drivers\etc\hosts
file.
NOTE: Add the public and virtual IP addresses to the hosts file only if they are
not registered with the DNS server.
For example, the following entries use the adapter IP and host name as
shown in Table 1-7:
IP AddressNode Name
155.16.170.1rac1
155.16.170.2rac2
10.10.10.1rac1-priv
10.10.10.2rac2-priv
155.16.170.201rac1-vip
155.16.170.202rac2-vip
NOTE: Registering the private IP addresses with the DNS server is not
required because the private network IP addresses are not accessible from
the public network.
5
Repeat step 1 through step 4 on the remaining nodes.
6
Ensure that the cluster nodes can communicate with the public and private
networks.
a
On node 1, open a command prompt window.
b
At the command prompt, enter:
ping <
public_host_name
>
ping <
private_host_name
>
where <
public_host_name
> and <
private_host_name
> are the host
names for the public and private network adapters in the remaining node.
If the nodes network adapters do not respond to ping commands, check
your network configuration and then repeat this step.
NOTE: Virtual internet protocol (VIP) is configured later and cannot be pinged
at this point.
c
Repeat step a through step b on the remaining nodes.
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 77 78

Commentaires sur ces manuels

Pas de commentaire