Dell PowerVault NX3000 Manuel d'utilisateur télécharger pdf (Page 105)

Installing System Components 105

Installing the Tape Backup Unit

WARNING: Only trained service technicians are authorized to remove the system

cover and access any of the components inside the system. Before you begin this

procedure, review the safety instructions that came with the system.

Turn off the system, including any attached peripherals, and disconnect

the system from its electrical outlet.

Open the system. See "Opening the System."

Remove the blank tray from the flex bay by squeezing the blue release tabs

at the back of the tray and pushing the tray out of the system.

Using a Phillips screwdriver, disassemble the blank tray:

For 3.5-inch hard-drive systems, remove the blank from the tray. See

Figure 3-18.

For a SCSI tape drive, route the SCSI data and power cables through the

flex bay and through the tray and connect the cables to the tape backup

unit.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 115 116

Pas de commentaire

Dell PowerVault NX3000 Manuel d'utilisateur Page 105