Dell OpenManage Integration for VMware vCenter 2.1 Guide d'installation télécharger pdf (Page 13)

9. Run the Inventory on all the registered vCenters.

NOTE:

It is recommended that you run the inventory on all the hosts managed by the plug-in again after the upgrade.

For more information, see the section Running Inventory Jobs for steps to run the inventory on demand.

If the IP address of the new OpenManage Integration version 2.1 appliance has changed from that of the old

appliance, the trap destination for the SNMP traps must be configured to point to the new appliance. For 12G

servers, this will be fixed by running the Inventory on these hosts. For all 11G or lower generation hosts that

were earlier complaint, this IP change will show up as non-complaint and will require configuring OMSA. For

more information, see the section, Running the Fix Non-Compliant VSphere hosts Wizard to fix the host

compliance in the OpenManage Integration for VMWare vCenter Version 2.1 User Guide.

How to recover if I have unregistered the older plugin after the backup

If you have unregistered the plug-ins after taking backup of the database of the older version, perform the following

steps before proceeding with the migration.

NOTE: Unregistering the plug-in has removed all the customizing that was done on the registered alarms by the

plug-in. The following steps will not be able to restore the customizing, however, it will re-register the alarms in

the default state.

1. Perform the steps 3-5 in the section Migration Path to migrate from 1.6/1.7 to 2.1.

2. Register the plug-in to the same vCenters that you had registered earlier in the older plug-in.

3. Proceed with step 6 through step 9 in the section Migration Path to migrate from 1.6/1.7 to 2.1 to complete the

migration.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Dell OpenManage Integration for VMware vCenter 2.1 Guide d'installation Page 13