Dell OPENVIEW NNM SE 1.2 Guide de dépannage télécharger pdf (Page 148)

A-10 Installation and Troubleshooting Guide

Diag_Flt: the port failed diagnostics (defective G_Port

card or motherboard)

Port is OK (Solid Green LED):

The port is online and connected to a device over the cable.

Port is segmented (Slow Flashing Green LED):

Port is online but segmented.

Please check for loopback cable or incompatible switch.

Port has an internal loopback (Fast Flashing Green LED):

The port is configured as a loopback port by diagnostics to

verify the proper functioning of the internal Fibre Channel

port logic and paths between the interface and the central

memory. portEnable will put the port back online again.

Port is sending data (Flickering Green LED):

The port is online and transmitting/receiving frames.

Thermometer Error Message

Temperature out of range:

One or more temperature sensors have exceeded the minimum or

maximum allowed temperature reading (Minimum temperature is

zero degrees Centigrade, maximum is 75o degrees Centigrade).

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 154 155 156

Pas de commentaire

Dell OPENVIEW NNM SE 1.2 Guide de dépannage Page 148