Dell Active Fabric Manager Guide de l'utilisateur télécharger pdf (Page 15)

– Selecting a Layer 2 VLT and Layer 3 with Resiliency (Routed VLT) Fabric Design

3. Build the physical network.

4. Configure the following settings:

– TFTP/FTP

– SNMP

– CLI Credentials

5. Prepare the Fabric for Deployment

6. Deploy and Validate the Fabric

7. Validate the deployed fabric against the fabric design.

8. Monitor the fabric health and performance. See Performance Management.

NOTE: To provision the fabric, enter the Dell Networking operating system (FTOS) CLI user’s Credentials and

enable the configuration credential for all the switches in the fabric. For information about this topic, see CLI

Credentials.

CAUTION: If you are using a switch that has already been deployed, reset its factory settings in the fabric. The

switch must be in Bare Metal Provision (BMP) mode.

Designing and Deploying a Fabric Flowchart

The following flowchart shows how to design and deploy a new fabric.

Figure 2. Capacity Planning

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 178 179

Pas de commentaire

Dell Active Fabric Manager Guide de l'utilisateur Page 15